Internet Engineering Task Force I. Hussain Internet-Draft R. Valiveti Intended status: Standards Track K. Pithewan Expires: January 8, 2017 Infinera Corp July 7, 2016 FlexE GMPLS Signaling Extensions draft-hussain-ccamp-flexe-signaling-extensions-00 Abstract This document describes GMPLS signaling extensions for configuring a FlexE group and adding or removing FlexE client(s) to a FlexE group [OIFFLEXE1]. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at http://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on January 8, 2017. Copyright Notice Copyright (c) 2016 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (http://trustee.ietf.org/license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Simplified BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Simplified BSD License. Hussain, et al. Expires January 8, 2017 [Page 1] Internet-Draft FlexE Signaling July 2016 Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 1.1. Requirements Language . . . . . . . . . . . . . . . . . . 2 2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . . 2 3. Protocol Extensions . . . . . . . . . . . . . . . . . . . . . 3 3.1. Generalized Label . . . . . . . . . . . . . . . . . . . . 3 3.2. FlexE Group Initial Setup . . . . . . . . . . . . . . . . 4 3.3. FlexE Client Setup . . . . . . . . . . . . . . . . . . . 5 3.4. Related Work . . . . . . . . . . . . . . . . . . . . . . 5 4. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 5 5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 5 6. Security Considerations . . . . . . . . . . . . . . . . . . . 5 7. References . . . . . . . . . . . . . . . . . . . . . . . . . 6 7.1. Normative References . . . . . . . . . . . . . . . . . . 6 7.2. Informative References . . . . . . . . . . . . . . . . . 6 Appendix A. Additional Stuff . . . . . . . . . . . . . . . . . . 6 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 6 1. Introduction This document describes GMPLS signaling extensions for configuring a FlexE group and adding or removing FlexE client(s) to a FlexE group [OIFFLEXE1]. The various usecases that arise when transporting Flexible Rate Ethernet signals in Optical transport networks are described in [FLEXEUSECASES]. The routing extensions in support of carrying link state information for a FlexE group are described in [FLEXEROUTING]. 1.1. Requirements Language The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119]. 2. Terminology a. Ethernet PHY: an entity representing 100G-R Physical Coding Sublayer (PCS), Physical Media Attachment (PMA), and Physical Media Dependent (PMD) layers. b. FlexE Group: a group of from 1 to 254 bonded Ethernet PHYs. c. FlexE Client: an Ethernet flow based on a MAC data rate that may or may not correspond to any Ethernet PHY rate (e.g., 10, 40, m x 25 Gb/s). Hussain, et al. Expires January 8, 2017 [Page 2] Internet-Draft FlexE Signaling July 2016 d. FlexE Shim: the layer that maps or demaps the FlexE clients carried over a FlexE group. e. FlexE Calendar: Representation of a FlexE group of n PHYs as a calendar of 20n slots logical length with 20 slots per PHY for scheduling of slots (i.e., a PHY bandwidth) among the FlexE clients. 3. Protocol Extensions This section describes extensions to RSVP-TE signaling for GMPLS [RFC3473] to support FlexE. 3.1. Generalized Label Figure 1 shows the proposed FlexE generalized label format to be carried in the Generalized Label Request [RFC3471]. This document proposes LSP Encoding type = Flexible Ethernet (FlexE) (a new value of 15 as defined in [FLEXEROUTING]), Switching type = Layer-2 Switch Capable (L2SC) (a value of 51 as defined in [RFC3471]) and Generalized PID (G-PID) = FlexE (a new value of 71 as defined in this document). A FlexE Group consists of 1 to n 100GBASE-R Ethernet PHYs. The label lists all PHY numbers (1 to 254) that are members of the FlexE group. For a client, the label also lists calendar slots in each member PHY that are assigned to the client. 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 +---------------------------------------+-----------------------+ | FlexE Group Number | Reserved | +---------------------------------------+-----------------------+ | Client (being added or removed) | Flags | +----------------+--------------------------------+-------------+ | PHY Number | Rate | Granularity | Unav. Slots | +----------------+----------------+-------------+-+-------------+ | Slot Map (0 to 19 slot for 100G PHY) | Reserved | +-----------------------------------------------+---------------+ | ...... | +----------------+----------------+---------------+-------------+ | PHY Number | Rate | Granularity | Unav. Slots| +----------------+----------------+-------------+-+-------------+ | Slot Map (0 to 19 slot for 100G PHY) | Reserved | +-----------------------------------------------+---------------+ | ...... | +---------------------------------------------------------------+ Figure 1: FlexE Generalized Label Hussain, et al. Expires January 8, 2017 [Page 3] Internet-Draft FlexE Signaling July 2016 FlexE Group Number (20 bits) fields allows to check that the correct PHY is being received from the correct group number [OIFFLEXE1]. Client (16 bits) field indicates which of the FlexE clients is mapped into a given calendar slot in the A and B calendar configurations for the sub-calendar carried over that PHY [OIFFLEXE1]. Flags (8 bits) field is reserved for future use. [OIFFLEXE1]. PHY Number (8 bits) field is used to identify PHY by a number in the 1-254 range [OIFFLEXE1]. Rate (8 bits) field is used to specify rate of the given PHY number. Currently [OIFFLEXE1] has defined a 100G PHY rate. In the future, this field may be used to indicate other PHY rates (e.g., 400G). Granularity (8 bits) field is used to indicate granularity of the FlexE calendar. Currently [OIFFLEXE1] has defined 5G granularity. In future, this field can have additional values, as further granularity are defined. Slot Map (20 bits) field is used to indicate which calendar slots of the associated PHY number is assigned to a given FlexE client. For a PHY with a rate of 100G and granularity of 5G, the slot map consists of 20 slots (0-19 range). In the future, when other PHY rates and/or calender granularities are defined, the slot map size for a PHY can be derived based on the Rate and Granularity fields values. Unavailable Slots (8 bits) field is used to indicate the number of unavailable calendar slots (0-19 range) for example due to transport network constraints (i.e., no FlexE client should be assigned to the unused slots). Unavailable slots are placed at the end of each relevant sub-calendar (i.e., the highest numbered slots) [OIFFLEXE1]. 3.2. FlexE Group Initial Setup Suppose it is desired to establish a FlexE group containing two 100G PHYs between node A and B. This can be accomplished by having node A send a RSVP-TE message containing a FlexE generalized label to node B with the following field values: a. FlexE Group Number = 100 (say), Client = 0x0000 (i.e., no client) Hussain, et al. Expires January 8, 2017 [Page 4] Internet-Draft FlexE Signaling July 2016 b. First PHY Number = 5 (say), Rate= 100G, Granularity=5G, Unavailable Slots=0, Slot Map = 0-19 bit set to 0 (i.e., all slots available) c. Second PHY Number = 7 (say), Rate-100G, Granularity=5G, Unavailable Slots=0, Slot Map = 0-19 bit set to 0 (i.e., all slots available) Thus both ends will have the same FlexE group configuration and the FlexE group can be brought in service. 3.3. FlexE Client Setup Suppose it is desired to establish a FlexE client of rate 50G node A and B to the FlexE group created in the Section 3.2. This can be accomplished by having node A send a RSVP-TE message containing a FlexE generalized label to node B with the following field values: a. FlexE Group Number = 100, Client = 0x0001 (i.e., client id = 1) b. First PHY Number = 5 , Rate= 100G, Granularity=5G, Unavailable Slots=0, Slot Map = 0 to 4 bit set to 1 (i.e., 25G on this PHY) c. Second PHY Number = 7, Rate-100G, Granularity=5G, Unavailable Slots=0, Slot Map = 0 to 4 bit set to 1 (i.e., 25G on this PHY) 3.4. Related Work The generalized label described in [FLEXESIGNAL] is limited to 100G PHY only. In contrast, the generalized label proposed in this document is extendible to PHY rates beyond 100G. Specifically, the label proposed in this document introduces additional per PHY fields, namely, Rate and Granularity. This enables to drive per PHY calendar size information in the face of calendar granularity and/or calendar size changes that might be required for PHY rates beyond 100G (such as 400G). 4. Acknowledgements 5. IANA Considerations This memo includes no request to IANA. 6. Security Considerations None. Hussain, et al. Expires January 8, 2017 [Page 5] Internet-Draft FlexE Signaling July 2016 7. References 7.1. Normative References [FLEXEROUTING] IETF, "FlexE GMPLS Routing Extension, draft-pithewan- ccamp-flexe-routing-extensions", June 2016. [FLEXESIGNAL] IETF, "RSVP-TE Signaling Extensions in support of Flexible Ethernet networks, draft-wang-ccamp-flexe-signaling-00", March 2016. [FLEXEUSECASES] IETF, "FlexE Usecases, draft-hussain-ccamp-flexe- usecases", June 2016. [OIFFLEXE1] OIF, "FLex Ethernet Implementation Agreement Version 1.0 (OIF-FLEXE-01.0)", March 2016. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . [RFC3471] IETF, "G Generalized Multi-Protocol Label Switching (GMPLS) Signaling Functional Description, RFC3471", January 2003. [RFC3473] IETF, "Generalized Multi-Protocol Label Switching (GMPLS) Signaling Resource ReserVation Protocol-Traffic Engineering (RSVP-TE) Extensions, RFC3473", January 2003. 7.2. Informative References [OIFMLG3] OIF, "Multi-Lane Gearbox Implementation Agreement Version 3.0 (OIF-MLG-3.0)", April 2016. Appendix A. Additional Stuff This becomes an Appendix. Authors' Addresses Hussain, et al. Expires January 8, 2017 [Page 6] Internet-Draft FlexE Signaling July 2016 Iftekhar Hussain Infinera Corp 169 Java Drive Sunnyvale, CA 94089 USA Phone: +1-408-572-5200 Email: IHussain@infinera.com Radha Valiveti Infinera Corp 169 Java Drive Sunnyvale, CA 94089 USA Phone: +1-408-572-5200 Email: rvaliveti@infinera.com Khuzema Pithewan Infinera Corp 169 Java Drive Sunnyvale, CA 94089 USA Phone: +1-408-572-5200 Email: kpithewan@infinera.com Hussain, et al. Expires January 8, 2017 [Page 7]